To the question of reinforcement bezbalochnyh floors using PC SAPPHIRE
Abstract
To the question of reinforcement bezbalochnyh floors using PC SAPPHIRE
Incoming article date: 15.05.2017In the article the results of reinforcement of monolithic reinforced concrete slab bezbalochnyh, different parameters of a finite element mesh, under other equal characteristics. Of course cell model was created by means of PC SAPPHIRE with subsequent transfer of analytical model in LIRA-CAD when creating analytical models used three variants of triangulation, namely: rectangular, triangular and adaptive step triangulation ranged over a wide range-from 1/6 up to 1/30 span. Bearing slabs at columns was carried out on two variants : using an absolutely rigid body and without it. The subject analysis of selected area of the upper longitudinal bearing fittings. During the analysis process was investigated the influence of automatic finite element mesh triangulation on anchor square fittings. Found that in all cases an increase in triangulation step reduces the required for calculating the square top of the longitudinal reinforcement. This reduction may reach 85%, and in case of insufficient quality control finite element mesh is going to cause a serious error in the calculation. When automatically generating a mesh leaf size can significantly exceed step triangulation. All meshes with the zone of transition from AGT to the plate in the form of triangles effect is observed the increase required for calculating reinforcement as you go further away from the brink of columns, that in our view it is illogical. Practical value as the most simple way, has the option of split slabs into rectangular finite elements with a size equal to or slightly greater than the section of the column. without the use of absolute hard bodies.
Keywords: monolithic frame, non-beam overlapping, triangulation, selection of reinforcement, design calculation, PC SAPPHIRE, PC LIRA-CAD